Latency (engineering)

Latency is a measure of time delay experienced in a system, the precise definition of which depends on the system and the time being measured. In communications, the lower limit of latency is determined by the medium being used for communications. In reliable two-way communication systems, latency limits the maximum rate that information can be transmitted, … Continue reading →

dBm

dBm (sometimes dBmW) is an abbreviation for the power ratio in decibels (dB) of the measured power referenced to one milliwatt (mW). It is used in radio, microwave and fiber optic networks as a convenient measure of absolute power because of its capability to express both very large and very small values in a short form. Compare dBW, which is referenced to one watt … Continue reading →

Mobile Telecommunications

Originally posted on comfortuduebholo's Blog:
INTRODUCTION TO MOBILE TELECOMMUNICATION During the early 1980s, analog cellular telephone systems were experiencing rapid growth in Europe, particularly in Scandinavia and the United Kingdom, but also in France and Germany. Each country developed its own system, which was incompatible with everyone else’s in equipment and operation. This was…

Power line communication (PLC)

Power Line Communication (PLC) is a communication technology that enables sending data over existing power cables. This means that, with just power cables running to an electronic device (for example) one can both power it up and at the same time control/retrieve data from it in a half-duplex manner. Source